FEATURES
FOUR POSITION CASING
Discharge can be located in any of four positions.
Casing is close grain iron of 30,000 psi minimum tensile
strength. Back pull-out design eliminates the need to
disturb piping should the pump ever require service -
the casing stays in the line.
MECHANICAL SHAFT SEAL
Standard self-adjusting shaft seal for temperatures to
225°F (107°C) and pressures to 150 psi (1034 kpa).
Ceramic seat and carbon seal face for long trouble-free
service. Special seals are available for higher
temperatures and fluids other than water.
MOTORS
Standard pump motors are of open drip proof (ODP)
construction and are rated with jet pump service factors
for continuous duty operation. Motors are 56 frame size
with NEMA standard mounting flange, one piece
threaded stainless steel shaft and ball/ball bearing
construction.
FACTORY TESTED
After careful assembly and inspection, EVERY pump is
factory tested and meets Hydraulic Institute standards.
