GNA6-1-1/4-5.50

Burks GNA6-1-1/4 Series - Centrifugal Pump, Base Mounted

Adapter - All Iron: Cast Iron, Bronze Fitted: Cast Iron, All Bronze: Bronze, Stainless Steel: 316 Stainless Steel
Casing - All Iron: Cast Iron, Bronze Fitted: Cast Iron, All Bronze: Bronze, Stainless Steel: 316 Stainless Steel
Casing Wear Ring - All Iron: Steel, Bronze Fitted: Bronze, All Bronze: Bronze, Stainless Steel: 316 Stainless Steel
Impeller - All Iron: Cast Iron, Bronze Fitted: Bronze, All Bronze: Bronze, Stainless Steel: 316 Stainless Steel
Shaft: 316 Stainless Steel
Shaft Seal: Carbon Ceramic SS Buna-N

Discharge can be located in any of four positions. Casing is close grain iron of 30,000 psi minimum tensile strength. Back pull-out design eliminates the need to disturb piping should the pump ever require service - the casing stays in the line. Openings are provided for test gauges, for venting and for draining the pump.

Prevents wear on casing and is easy to replace.

Taking out only 4 cap screws allows removal of pumping assembly without disturbing piping.

Mechanical Shaft Seal is self-adjusting for temperatures up to 225°F (107°C) and pressures to 150 psi (1034kpa). Has ceramic seat and carbon seal faces for long trouble-free service. Special seals are available for higher temperatures and fl uids other than water. Tapped opening is provided in the seal chamber or flushing seal faces.

After careful assembly and inspection, EVERY pump is factory tested and will meet Hydraulic Institute standards.

Enclosed Bronze Impeller is of the latest hydraulic design for maximum effi ciency. It is balanced for vibration-free operation and threaded onto stainless steel motor shaft.

Series GNA5-1-1/4 and and all G6-1-1/4 pumps are available in a Jacketed Seal Cavity design for pumping hot oil, hot water and heat transfer fluids in common use in high temperature heating or cooling applications. This feature greatly extends seal life in high temperature applications. To order, add suffix "MJ" to pump catalog number for temperatures below 400°F (240°C) and add suffix "MJK" to pump catalog number for temperatures over 400°F (240°C). Example: GNA5-1-1/4MJ.

Furnished on all complete Base-Mounted units manufactured by Burks Pumps. Not furnished with purchase of pump only, but required.

Horizontal, vertical or on an angle.