P43B0005A2-01-40PK

Sta-Rite Pentek XE Series 4” Submersible Motors Features And Benefits:
Large high-performance 700# Kingsbury thrust bearing design allow higher thrust loads
Designed to provide many years of service under severe-duty opration
Permanent Split Capacitor (PSC) insures quiet operation and improved operating efficiency
All stainless-steel exterior
Professional-grade Class F compliant motor insulation allows for longer service life
Equipped with Surge Arrestor
Automatic Thermal Protection

Sta-Rite Pentek XE Series 4” Submersible Motors General Specifications:
NUMBER OF WIRES: 2 or 3 (plus ground) (Model Dependent)
HORSEPOWER: Available in 1/2, 3/4, 1, 1-1/2, 2, 3, 5, 7-1/2, and 10 HP
VOLTAGE: Single Phase: 115v or 230v AC / Three Phase: 200v, 230v, 460v, 575v
PHASE: 1- or 3-phase (model dependent)
FREQUENCY (Hz): 60
AMP DRAW and SERVICE FACTOR: (model dependent) See Spec Sheet in Resources for details
END BELL: 304 Stainless Steel
SHELL: 304 Stainless Steel
MOTOR SHAFT: 17-4 Precipitation Hardened Stainless Steel
INSULATION: Class E, 311 degrees F (155 degrees C)
MAX. WATER TEMP.: 86 degrees F (30 degrees C)
FASTENERS: 304 Stainless Steel
SAND BOOT: Nitrile
CABLE: 48", Field-Serviceable, Controlled Compression Design, UL and CSA Approved
DIAPHRAGM: EPDM
THRUST BEARINGS: Kingbury-type, Pivot Shoe, Carbon Graphite Mating Ring
THRUST LOAD CAPACITY: 700 lbs