PLC-2LMS3

Sta-Rite PL Series Convertible Deep Well Jet Pump Features And Benefits:
Superior Rustproof Construction - Pump body is Dura-Glas fiberglass reinforced thermoplastic - lightweight, rustproof and exceptionally strong. All components in contact with water are resistant to the corrosive and abrasive forces found in the most aggressive water conditions.
Heavy-duty Motor - Dustproof canopy completely encloses electrical components and provides dust, dirt and insect protection. Ventilating air cannot contaminate vital switching components. Permanently lubricated, heavy-duty ball bearings ensure smooth, quiet operation and extended motor life.
Precision Diffuser - Multi-port, reinforced polypropylene design primes faster and handles more air.
Precision Molded Impeller - Precision molded Noryl® gives perfect balance and ultra-smoothness for highest performance and efficiency.

Sta-Rite PL Series Convertible Deep Well Jet Pump General Specifications:
BODY CONSTRUCTION: Thermoplastic
HORSEPOWER: Available in 1/2 thru 1-1/2 HP
MAXIMUM CAPACITY: 26.3 GPM (Model PLE with Shallow Well Setup)
FLOW at 10' LIFT and 40 PSI: 13.8 GPM (Model PLD Shallow Well Setup)
MAX LIFT: 25' w/ Shallow Well jet Kit / 60' w/ Deep Well Jet Kit
MAX SHUT-OFF PRESSURE: 72 PSI (model PLC in shallow well config)
MAXIMUM TOTAL PRESSURE (Inlet + Pump Pressure): PLC: 72 PSI / PLD:62 PSI / PLE: 62 PSI / PLF: 64 PSI
PRESSURE SWITCH SETTING: 30-50 PSI
SUCTION SIZE: 1-1/4" NPR
DRIVE SIZE: 1" NPT (suction-over-drive)
DISCHARGE SIZE: 1" NPT
AMP DRAW (full load): 6.1 amps on 230v / 12.2 amps on 115v
VOLTAGE: 115v/230v AC, 60 Hz, 1-phase
MAXIMUM LIQUID TEMPERATURE: 140 F (60 C)